Followers

Tuesday, November 15, 2022

Get To Know About Stripping Fibers

A fiber gets damaged during stripping with a fiber stripper that won't always break right away. A damaged fiber has a good chance of surviving processing on the manufacturing line intact. There is no way to determine if the fiber has been harmed or not unless the weaker fiber breaks during industrial processing.

A wire stripper with the appropriate settings or a specialist fiber stripper can be used to cut and remove the cable jacket if the fiber is not damaged. Some fiber strippers are more practical because they contain grooves for both the jacket and the fiber. Cutting the aramid fibers requires the use of specialized, ultra-sharp scissors. Since doing so will ruin them and blunt the cutting edge, they shouldn't be utilized to cut anything else. We may now begin to strip the fibers. You must select the instrument you employ for this crucial phase. There are three different kinds of fiber optic stripping tools that are often employed; these are Miller, No-Nik, and Microstrip, respectively.


fiber stripper



Millers are fairly tough and have a wire stripper-like appearance, but using them takes skill. Millers are difficult for left-handed users to handle comfortably because they must hold them at an angle. Due to their lower technical requirements and ability to strip greater lengths of fiber at once, the other two strippers are typically preferred by fusion-splicer operators. To achieve thorough stripping, every tool has to be well cleaned with fiber cleaner.


Fiber Cleaner

It takes a certain amount of tugging to strip the fiber of its buffer layers. With one hand, you grasp the cable or fiber while using the other to grip the stripper. The fiber or cable may be held safely and firmly by wrapping it around a finger a few times.

After removing the colored plastic buffer coating with a 900-micron thickness, there can still be some residue on the fiber. When the stripper did not cut through both layers of coating, there was just the main buffer coating, which has a diameter of 250 microns, left. All of the residues should be eliminated by applying a tight clamp. If you can see portions of the inner buffer, you can strip once again forcefully gripping the stripper to cut through all buffer coats. The fiber cannot be placed into the connection if the buffer coating is not completely removed. You can buy fiber splicer online.


No comments:

Post a Comment