A fiber gets damaged during stripping with a
fiber stripper that won't always break right away. A damaged fiber has
a good chance of surviving processing on the manufacturing line intact. There
is no way to determine if the fiber has been harmed or not unless the weaker
fiber breaks during industrial processing.
A wire stripper with the appropriate settings or a
specialist fiber stripper can be used to cut and remove the cable jacket if the
fiber is not damaged. Some fiber strippers are more practical because they
contain grooves for both the jacket and the fiber. Cutting the aramid fibers
requires the use of specialized, ultra-sharp scissors. Since doing so will ruin
them and blunt the cutting edge, they shouldn't be utilized to cut anything
else. We may now begin to strip the fibers. You must select the instrument you
employ for this crucial phase. There are three different kinds of fiber optic
stripping tools that are often employed; these are Miller, No-Nik, and
Microstrip, respectively.
Millers are fairly tough and have a wire stripper-like
appearance, but using them takes skill. Millers are difficult for left-handed
users to handle comfortably because they must hold them at an angle. Due to
their lower technical requirements and ability to strip greater lengths of
fiber at once, the other two strippers are typically preferred by
fusion-splicer operators. To achieve thorough stripping, every tool has to be
well cleaned with fiber cleaner.
It takes a certain amount of tugging to strip the fiber
of its buffer layers. With one hand, you grasp the cable or fiber while using
the other to grip the stripper. The fiber or cable may be held safely and
firmly by wrapping it around a finger a few times.
After removing the colored plastic buffer coating with a
900-micron thickness, there can still be some residue on the fiber. When the
stripper did not cut through both layers of coating, there was just the main
buffer coating, which has a diameter of 250 microns, left. All of the residues
should be eliminated by applying a tight clamp. If you can see portions of the
inner buffer, you can strip once again forcefully gripping the stripper to cut
through all buffer coats. The fiber cannot be placed into the connection if the
buffer coating is not completely removed. You can buy fiber splicer online.
